Page 4 of 4 FirstFirst 1234
Results 31 to 33 of 33

Thread: AB Knives

  1. #31
    Living the Dream KDX's Avatar
    Join Date
    Apr 2012
    Posts
    278
    The recipient of the folder was hoping that it would have had a lanyard hole. As there was no room in the original design to put one in, so I thought I would try to make a new back spacer for him. Luckily I tend to keep scraps of material and had a piece of AEB-L (same as the blade) handy.



    I bought some layout fluid the other day and would say that it works pretty well.



    The end result didn't turn out too bad.





    The End is Near. Wear a helmet.

  2. The Following User Liked This Post By KDX

    lone-wolf (07-23-2017)

  3. #32
    Living the Dream KDX's Avatar
    Join Date
    Apr 2012
    Posts
    278
    I started on a flipper design. It's going to be a liner lock with a titanium scale on the lock side and a titanium slab on the other. I had to use a fly cutter on an aluminum plate to true it up.





    Drilled and tapped a bunch of holes.



    Drilled the pivot and stop pin and roughed out the handle.



    It will have an S35VN blade.
    The End is Near. Wear a helmet.

  4. #33
    Living the Dream KDX's Avatar
    Join Date
    Apr 2012
    Posts
    278
    I surface ground the last of my fixed blades this weekend, ground one of the large drop points and put a handle on it.





    Other than planning on doing a dagger some time this year, I don't think I will be making any more fixed blades as I want to concentrate on folders.
    The End is Near. Wear a helmet.

  5. The Following 2 Users Like This Post By KDX

    jwirecom109 (08-14-2017), TSE JR (08-14-2017)

Page 4 of 4 FirstFirst 1234

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •