I personally do not do any machining.The shop which produces adapters for me ,cut the stocks for me and than I just applied the epoxy and finished the assembly(I have 20 + years in aircraft maintenance .
Any machining and assembly should be done by gunsmith.
Any work on stock CAN NOT be done by hand or hand held power tools.
If the demand is there I will check the rate for machining of the stocks.More stocks to be machined lower the charge(price ) will be.But as I said I strongly recommend (and my lawyer too)that work and assembly is done by gunsmith.
Results 1 to 10 of 36
Threaded View
-
07-10-2017, 11:35 AM #3
-
The Following User Liked This Post By jv1
lone-wolf (07-10-2017)
Reply With Quote
Posting Permissions
