Welcome to the forum, just curious if you do the work on any of the stocks yourself?
As in, customer sends you his stock, and it comes back with the adapter? Probably be a decent demand for such service.
Welcome to the forum, just curious if you do the work on any of the stocks yourself?
As in, customer sends you his stock, and it comes back with the adapter? Probably be a decent demand for such service.
the wild still lingered in him and the wolf in him merely slept
"It must be poor life that achieves freedom from fear" - Aldo Leopold
I personally do not do any machining.The shop which produces adapters for me ,cut the stocks for me and than I just applied the epoxy and finished the assembly(I have 20 + years in aircraft maintenance .
Any machining and assembly should be done by gunsmith.
Any work on stock CAN NOT be done by hand or hand held power tools.
If the demand is there I will check the rate for machining of the stocks.More stocks to be machined lower the charge(price ) will be.But as I said I strongly recommend (and my lawyer too)that work and assembly is done by gunsmith.
lone-wolf (07-10-2017)