Page 5 of 5 FirstFirst 12345
Results 41 to 42 of 42
  1. #41
    Senior Member Petamocto's Avatar
    Join Date
    Mar 2014
    Location
    Rusagonis/Waasis, NB
    Posts
    6,673
    Rory, much appreciated and I will look into Williams.

    I'm okay with the Henry front sight, though, so hopefully moving the rear down a bit fixes my problem enough.

    It seems like I may be able to go down farther, but the threaded post of the screw is down as far as it can into the sight base.

    That post is very long, though, and if I'm able to take 1-2mm off of that, I should be able to get the round part of the peep right down flush with the base (it's still about 1mm off it, but it won't go any farther).
    I have no signature block.

  2. #42
    Moderator kennymo's Avatar
    Join Date
    Jul 2014
    Location
    Winnipeg, MB
    Posts
    12,444
    Make sure that the post is actually bottoming out and you haven’t just run out of threads on the shaft of the peep sight. Won’t matter how much you file off the bottom at that point, it’s time to die. (as in tap & die)
    Cleverly disguised as a responsible adult.

  3. The Following User Liked This Post By kennymo

    Petamocto (10-30-2019)

Page 5 of 5 FirstFirst 12345

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •