Bought a Stag 10 receiver set on sale at CTC. Have never built an AR type rifle, what tools will I need to buy for this build? Kinda wanted to go for a classic m16 look
Results 1 to 2 of 2
Thread: Stag 10 build help
-
11-29-2019, 03:47 PM #1Senior Member
- Join Date
- Feb 2015
- Location
- No where, and everywhere
- Posts
- 3,051
Stag 10 build help
Let me off this planet!
-
11-30-2019, 10:16 AM #2Senior Member
- Join Date
- Mar 2014
- Location
- Winnipeg
- Posts
- 5,921
True North has a lot of the tools. An AR10 sized reaction rod or a fixture (by Wheeler) that clamps to the top rail is essential, along with a bench vice to hold either, and a barrel nut wrench.
Then a torque wrench.
Roll pin punches and starter punches are nice to have, and a set of Allen wrenches..
Some moly grease for the barrel nut, and I like synthetic bearing grease for any hole I’m driving a pin into, or to keep springs from flying out when they slip - glop the spring with grease before installing it.Last edited by Mark-II; 11-30-2019 at 10:22 AM.
Schrödinger's Gat - The logical paradox which posits that a firearm, stored safe in the home, is at the same time On The Streets
Reply With Quote
Posting Permissions
